Service and Error Messages

Table 7-2 Service and Error Messages Table 7-2 Service and Error Messages The printer received more data from the computer than can fit in its available user memory. Press isrnii + ICWffTfflWB to print the transferred data (data loss may result), then make more memory available in the printer by removing some fonts, macros, or any other data from memory or, simplify the page sent to the printer or, install additional memory. (Note, if AUTO CONT ON the printer will automatically continue...

Transfer Roller Assembly

Handle the Transfer Roller from the ends only. Do not touch the surface of the Transfer Roller. Skin oils will affect its electrical characteristics, resulting in poor image transfer. 1 Grasp the shaft on either end of the Transfer Roller and lift upward to snap out of the plastic retainer clip (Figure 6-19, callout 1). 2 Lift the opposite end up and out of its retainer clip. Transfer Roller Assembly To Reinstall Transfer Roller Assembly To Reinstall Be sure that the non-gear end of the shaft...

Recycling Toner Cartridges

In order to reduce waste, Hewlett-Packard utilizes a recycling program for used toner cartridges. Cartridge components that do not wear out are recycled. Plastics and other materials are recycled. Hewlett-Packard pays the shipping costs from the user to the recycling plant. For each cartridge returned, HP donates one U.S. dollar to be shared by the Nature Conservancy and the National Wildlife Federation. To join this recycling effort, follow the instructions inside the toner cartridge box.

Faulty Image Examples

This section illustrates some image defects and their possible causes. Since there are many variables in the printing process, it is possible to encounter image defects that are not illustrated in the following illustrations. If you find a defect that is not illustrated, record the probable cause along with the printing environmental conditions and save a copy of the defect for future reference. Each example is followed by a table that lists in order the probable causes of the image defect....

Table 71Status Messages

Control panel display remains blank. 1. Verify the input power, then check that CB101 and F101 are not open. 2. Check and reseat connector from the Control Panel to the Formatter PCA. 3. Remove any interface cables to the host. 4. Print an Engine Test to determine if the print engine is functional. If so, replace the Control Panel, then the Formatter pCa. The default ready message. The printer is ready to use. Printer is in Power Save mode. In Power Save mode all...