To duplex manually on lightweight media

1. Make sure that the straight-through output door is closed.

2. In the software program, open the device properties (printer driver). For instructions, see To change settings for a print job (Windows) or To change settings for a print job (Macintosh).

3. On the Finishing tab (the Paper Type/Quality tab for some Macintosh drivers), select Print on Both Sides. Make sure that Straight Paper Path is not selected.

Note If the Print on Both Sides option is dimmed or unavailable, open the device properties

(printer driver). For instructions, see To change default settings across all programs (Windows) or To change default settings across all programs (Macintosh). On the Device Settings tab or the Configure tab, select Allow Manual Duplexing, and then click OK. Repeat steps 2 and 3.

Not all device features are available for all printer drivers or operating systems. See the device properties (driver) online Help for information about the available features for the driver.

4. Print the document.

5. After side one has been printed, remove the remaining media from the input tray, and set it aside until after you finish your manual duplexing job.

6. Gather the printed pages, keep the printed side facing down, and straighten the stack.

7. Place the stack of media in the input tray again. Side one should be facing down with the bottom edge feeding into the device first. Replace the priority input tray.

8. Click OK (on the computer screen), and then wait for side two to print.

0 0

Post a comment